Seite 1 von 1

PiCam Module - UART Serial access

Verfasst: Di Dez 21, 2021 8:38 pm
von nettleand
Hi,
Can I use the EEPROM pins on the PiCam Module Board to access the Uart Serial pins on the CM4 (GPIO 14 TXD & 15 RXD on the standared Pi)?

If not is there any other way to access the CM4's Uart Serial via this board? Or is USB the only option?

Thanks in advance!

Re: PiCam Module - UART Serial access

Verfasst: Di Feb 22, 2022 7:41 am
von nostapowicz
Hi nettleand,

no you can´t use the EEPROM pins to access the GPIO pins. The EEPROM pins are EEPROM_nWP Pin1 and Ground Pin2.
From the cm4io-datasheet: "EEPROM_nWP If fitted write protects the EEPROM on the CM4".

https://datasheets.raspberrypi.com/cm4i ... asheet.pdf

None of the Uart Serial Pins from the cpu are connected to the board so USB ist the only option you have.